1. Positive battery cable
2. Positive battery post
3.
Disconnect the positive (red) cable from the
battery post
(Figure
4.
Tilt both seats forward and secure them by
moving the prop rods into the detents at the end
of the slots at the center-console base.
5.
Allow the engine to cool completely.
9
Removing the Seat and the
Engine-Access Panel
Multi Pro 1750 Machines
No Parts Required
Removing the Seat
1.
Remove the 2-socket connector of the machine
wire harness that connects to the seat-switch
connector
(Figure
Figure 30
3. Negative battery post
4. Negative battery cable
30).
31).
g029414
1. 2-socket connector
(machine wire harness)
2.
Remove the hairpin that secures the prop rod
to the bracket at the bottom of the seat plate
(Figure
32).
1. Washer
2. Bracket (seat)
3.
Remove the 2 hairpins that secure the pivot
fitting of the seat plate to the chassis brackets
(Figure
33).
14
Figure 31
2. Seat-switch connector
Figure 32
3. Hairpin
4. Prop rod
g024098
g024092