Connecting The Battery - Toro GeoLink CL-55 Installation Instructions Manual

Figure 90
1. Flange-head bolt (5/16 x
1 inch)
2. Modem bracket
3. Assemble the modem bracket to the right
seat-box panel and the air-cleaner mount
(Figure 90 and Figure
bolts (5/16 x 1 inch) and 2 flange locknuts (5/16
inch) that you removed in
(page 30).
g310540
3. Capscrew (5/16 x 3/4)
4. Right seat-box panel
91) with the 2 flange-head
Preparing the Machine
1. Flange locknut (5/16 inch)
2. Capscrew (5/16 x
3/4—coolant reservoir
bracket)
4. Assemble the modem bracket to the right
seat-box panel and the coolant reservoir bracket
(Figure 90 and
(5/16 x 3/4) and flange locknut (5/16).
5. Tighten the flange-head bolts, capscrew, and
flange locknuts.
17

Connecting the Battery

No Parts Required
Assembling the Rear GeoLink
Harness, Navigation-Data and
Electrical Harness, and Modem
Power Harness to the Battery
Cables
Multi Pro 1750 Machines
1. Assemble the following wire and cable terminals
onto the threaded post of the positive battery
terminal (Figure
Important:
Ensure that the battery-cable
terminal (positive) to the engine starter is
positioned at the top of the stack of terminals
on the threaded post.
A. Ring terminal—165 cm (65 inch) modem
power harness branch (labeled
34
Figure 91
3. Flange-head bolt (5/16 x 1
inch—air-cleaner mount)
Figure 91) with the capscrew
92) in the following order:
BATTERY
g310536