Table of Contents
Advertisement
Figure 26
1. Screw
2. Front panel
3. Control box
3. Lift and remove the 2 plugs from the spray control
panel on the vehicle and install the 2 rocker switches
provided in their place (Figure 26).
4. Plug the connector with the yellow/blue wire to the
left switch and the connector with the blue/green
wire to the right switch.
Note: Ensure that the orientation of the switches
mates with the orientation of the connector.
5. Install the front control panel to the control box and
secure it with the 4 screws loosened previously.
6. Insert the 15-amp fuse in the top slot in the fuse
block. Make sure the corresponding wire in the
fuse block is connected to the red/black wire in the
harness (Figure 27).
Figure 27
1. 15-amp
2. Fuse block
4. Plug
5. Rocker Switch
6. Connectors
3. Fuse box decal
5
Completing the Installation
Parts needed for this procedure:
2
Boom hose
2
Grommet
2
Punched-hole boom cap
2
Extension hose
2
Hose clamp, large
1
Parts catalog
Procedure
For all sprayers, serial number 259999999 and lower
Note: If you are installing this kit on a previously
setup sprayer, you may need to disassemble the boom
assembly for steps 1 through 10 below.
1. Locate, mark, and drill (through the top surface only)
a hole (5/8 inch dia) 1-1/2 inch from the plugged
end of the right boom pipe (Figure 28).
Note: On some booms, this hole exists. If drilling a
hole is not necessary skip ahead to 5.
1. Left boom pipe
2. Right boom pipe
2. Repeat for the left boom pipe.
3. Use a round file or deburring tool to deburr the
holes you drilled in the boom pipes (Figure 28).
4. Insert a drift punch into the 5/8 inch holes in the
boom pipes and distort the openings as shown in
Figure 28.
11
Figure 28
3. Boom plug
4. Hole, 5/6 inch, drilled,
de-burred and distorted
Advertisement
Table of Contents
