Table of Contents
Advertisement
15
Assembling the Modem
Power Harness to the
Machine
Parts needed for this procedure:
Modem power harness—1850 mm (72-7/8
1
inches)—GeoLink precision spray system kit (Model
41633 or Model 41634)
Cable ties—GeoLink precision spray system kit
5
(Model 41633 or Model 41634)
Routing the Modem Power
Harness
Multi Pro 1750 Machines
1.
Align the modem power harness to the machine
as shown in
Figure
Figure 69
1. Modem power harness
2.
Route the ring terminals of the modem power
harness labeled
BATTERY
the battery
(Figure
69.
and
toward
GROUND
70).
1. 9-pin connector (labeled
RS232—modem power
harness; not used)
3.
Route the 4-pin connector labeled
-55 and the 18-socket connector labeled CL55
CL
of the modem power harness under the fuse
block of the machine.
Note:
The connector labeled RS232 is not
used.
4.
At the front of the machine, route the 4-pin
connector labeled
18-socket connector labeled CL55 of the modem
power harness to the machine as shown in
Figure
71.
g315593
1. 4-pin connector (labeled
ETHERNET CL
data harness)
2. 18-socket connector
(labeled CL55—modem
power harness)
26
Figure 70
2. Ring terminals (labeled
BATTERY and
GROUND—modem power
harness )
-55 and the
ETHERNET CL
Figure 71
3. Socket connector (options
-55—modem
power—fuse block)
g315594
ETHERNET
g323053
Advertisement
Table of Contents
