Installing The Console Mounting Bracket - Toro Multi Pro WM 41240 Operator's Manual

Multi Pro Workman Turf Sprayer
Finishing Kit (HD-Series Models
with a Manual Transmission)
For HD- and HDX-Series Workman models with
a manual transmission, complete the steps in the
Multi Pro WM Turf Sprayer Finishing Kit for Manual
Workman Utility Vehicles; refer to the Installation
Instructions for the Multi Pro WM Turf Sprayer
Finishing Kit, Manual Workman Utility Vehicle.
Multi Pro Workman Turf Sprayer
Finishing Kit (HDX-Auto Model)
HDX-Automatic Series Workman models, complete
the steps in the Multi Pro WM Turf Sprayer Finishing
Kit for Automatic Workman Utility Vehicles; refer to
the Installation Instructions for the Multi Pro WM Turf
Sprayer Finishing Kit, Automatic Workman Utility
Vehicle.
3
Installing the Console
Mounting Bracket
Parts needed for this procedure:
1 Console mounting bracket
3 Flange locknut (5/16 inch)
3
Flange-head bolt (5/16 inch)
2 Plastic bushing
Procedure
Note:
On some Workman vehicles, the control mount
plate is attached to the dashboard at the same location
where the bracket for the optional hand throttle kit
is mounted. If the hand throttle kit is installed, you
will need to remove the bracket of the hand throttle
assembly from the dashboard, align the control mount
plate to the dash, and install the hand throttle bracket
on top of the control mount plate. Refer to the Hand
Throttle Kit Installation Instructions for directions on
removing and installing the hand throttle assembly.
1. Remove the 3 bolts and 3 nuts that secure the
lower-center portion of the dash panel to the
dash support bracket
Note:
Some older Workman machines may use
4 bolts and flange nuts.
(Figure 7).
Note:
Discard the bolts and nuts.
1. Bolt
2. Nut
3. Cash panel (lower center
area)
4. Mounting bracket (control
console)
2. Align the holes in the mounting bracket for the
control console with the holes in the dash and
support bracket
3. Assemble the mounting bracket dash panel and
support bracket with the 3 flanged-head bolts
(5/16 x 1 inch) and 3 flanged locknuts (5/16 inch)
4. Torque the nuts and bolts to
5. Insert the 2 plastic bushings into the mounting
bracket (Figure
17
Figure 7
5. Bushing (plastic)
6. Flanged-head bolts (5/16
x 1 inch)
7. Flanged locknuts (5/16
inch)
(Figure 7).
(Figure 7).
7).
g028408