Installing The Power Take-Off (Pto) Kit(For Workman Hd And Hdx Series Only); Installing The Control Console; Installing The Console Mounting Bracket; No Parts Required - Toro Multi Pro WM 41240 Operator's Manual

1. Left rear corner of bed
2. Vehicle frame channel
3. Pivot plate
CAUTION
The full bed weighs approximately 95 kg (210
lbs), so do not try to install or remove it by
yourself. Get the help of 2 or 3 other people or
use an overhead crane.
7. Lift the bed off the vehicle.
8. Store the cylinders in storage clips. Engage the
hydraulic lift lock lever on the vehicle to prevent
accidental extension of the lift cylinders.
2
Installing the Power
Take-Off (PTO) Kit
(for Workman HD and HDX
series only)

No Parts Required

Procedure
Suspend the setup of the Multi Pro WM at this time to install
the PTO kit. Refer to the accompanying Installation Instructions
for more information.
Continue to the next step once you have installed the kit.
Figure 4
4. Clevis pin
5. Lynch pin
3

Installing the Control Console

Parts needed for this procedure:
1

Control console

1

Hair pin

Mount the control console onto the storage bracket located
on the front right tank strap with a hair pin (Figure 5).
1
2
3
1. Control console
2. Storage bracket
4
Installing the Console
Mounting Bracket
Parts needed for this procedure:
1

Console mounting bracket

3

Flange nut (5/16 inch)

3

Flange head bolt (5/16 inch)

2

Plastic bushing

On some vehicles, the control mount plate is attached to
the dashboard at the same point the hand throttle assembly
is mounted. If the hand throttle kit is installed separate it
from the dashboard to install the control mount plate. Refer
to the Hand Throttle Kit Operator's Manual for directions in
removing and installing the hand throttle assembly.
13
Figure 5
3. Hair pin
G022351