Brake Shut-Off Valve Circuit Operation - Navistar International DT 466 Diagnostic/Troubleshooting Manual

Hide thumbs Also See for International DT 466:
Table of Contents

Advertisement

336
7 ELECTRONIC CONTROL SYSTEMS DIAGNOSTICS

Brake Shut-off Valve Circuit Operation

Figure 397 Brake Shut-off Valve circuit diagram
The brake shut-off valve is supplied ground to Pin 1
from the battery through Pin 4 of the 12-pin connector
and then through Pin A of the valve cover gasket. The
ECM controls the engine brake by supplying 12 volts
through Pin C of the valve cover gasket to Pin 2 of the
brake shut-off valve.
Fault Detection / Management
An open or short to ground in the brake shut-off valve
control circuit can be detected by an on demand
Output Circuit Check (OCC) during KOEO Standard
Test. If there is a circuit fault detected a DTC will be
set.
When the engine is running, the ECM compares
engine brake control pressure to injection control
pressure and BCP desired.
activated, brake control pressure will equal injection
control pressure.
If the brake control pressure does not match injection
control pressure, the ECM will disable the engine
brake, a DTC will be set, and the amber ENGINE
lamp will be illuminated.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
When the brake is
EGES-270-1
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
When the engine brake is not active and the ECM
detects an undesired value, the ECM will set a DTC
and the amber ENGINE lamp will be illuminated.
A bias BCP sensor can also cause the fault. The brake
shut-off valve and the BCP sensor circuit should both
be diagnosed.
Brake Shut-off Valve Diagnostic Trouble Codes
(DTCs)
DTCs are read using the EST or by counting the
flashes from the amber and red ENGINE lamp.
DTC 247
Engine brake enable OCC self-test failed
DTC 247 is set by the ECM when the OCC test
has failed after the KOEO Standard Test has been
run.
DTC 247 can be set when a poor connection,
an open or short to ground in the brake shut-off
valve control circuit, or a failed brake shut-off
valve solenoid exists.

Advertisement

Table of Contents
loading

This manual is also suitable for:

International dt 570International ht 570

Table of Contents