Navistar International DT 466 Diagnostic/Troubleshooting Manual page 164

160
• If ICP voltage is out of specification at engine
crank only, do Test 14 – "Low ICP System
Pressure" (page 186).
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
5 HARD START AND NO START DIAGNOSTICS
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
• If ICP voltage is in specification at KOEO
and builds to cranking voltage during engine
crank, continue to "Monitoring BCP using VC
Gasket Breakout Harness" test
EGES-270-1