Entering Vehicle Information Using The Est - Navistar International DT 466 Diagnostic/Troubleshooting Manual

2. Do the following procedure "Entering Vehicle
Information using the EST" to complete the rest
of the form heading:

Entering Vehicle Information using the EST

Figure 170 American Trucking Association
(ATA) connector
Figure 171 EZ-Tech® interface cable
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
5 HARD START AND NO START DIAGNOSTICS
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
Figure 172 EZ-Tech® interface cable
WARNING: To avoid serious personal injury,
possible death or damage to the engine or
vehicle, read all safety instructions in the "Safety
Information" section of this manual.
1. Connect the EZ-Tech® interface cable to the EST
and the ATA connector.
2. Boot-up EST.
Figure 173 International® launchpad
3. Select Engine Diagnostics, then International®
MasterDiagnostics® II.
EGES-270-1
149