Accessing Dtcs - Navistar International DT 466 Diagnostic/Troubleshooting Manual

5. Select VIN+ icon to open VIN+ session.
6. Use the on-screen information and the following
"Information List" to complete the form heading.
Table 1
Heading Information
Miles
Hours
VIN
Transmission
Ambient temperature
Coolant temperature.
Engine SN
Engine HP
Engine Family Rating
Code
ECM calibration
(Example for reference
only)
IDM calibration
(Example for reference
only)
Information List
• Miles (for warranty)
• Hours (for warranty)
• VIN (for warranty, ordering parts, and service
information) The Vehicle Identification Number is
also on the door jamb on the operators side.
• Transmission: Manual/Auto
• Ambient temperature
• Coolant temperature
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
5 HARD START AND NO START DIAGNOSTICS
VIN+ session PID
Odometer
Engine Hours
Vehicle ID
Transmission Type
Manual
Non-Isochronous
Manual Isochronous
Allison AT/MT
Allison MD
Intake Air Temp
Coolant Temp
Engine Serial Number
Rated HP
EFRC: Engine Family
Rating Code
Reference Number
PRE1PJ02
(First group)
Reference Number
ANZKLA02
(Second group)
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
• Engine SN (for ordering parts and service
information)
The engine serial number is stamped on a
crankcase pad on the right side of the crankcase
below the cylinder head.
number is also on the engine emission label on
the valve cover.
Compare the
Programming window of the VIN+ session with
the Engine SN on the engine. The engine could
have been replaced without a programming
change to the ECM to upgrade the Engine SN.
• Engine HP (for correct engine application)
• Engine Family Rating Code (for warranty)
• ECM calibration
• IDM calibration
NOTE: Fill in the Turbocharger No. and Injector No. if
a mismatch of components is suspected.
• Injector No. (requires removal of valve cover and
high-pressure oil rail)
• Turbocharger No.
turbocharger – may require removal of paint from
plate)

Accessing DTCs

WARNING: To avoid serious personal injury,
possible death or damage to the engine or
vehicle, read all safety instructions in the "Safety
Information" section of this manual.
NOTE: When opening VIN+ session to fill out form
heading, the DTC window automatically appears.
NOTE: If an EST is not available, see "Accessing
DTCs" in Section 3 .
Figure 175 DTC window
EGES-270-1
The engine serial
Engine SN in the
(Check for plate on
151
Vehicle