Table of Contents
Advertisement
560
3-Banana Plug Harness
Figure 520 ZTSE4498
The 3-Banana Plug Harness is used for operational
diagnostics of sensor circuits.
VC Gasket Breakout Harness
Figure 521 ZTSE4658A
The VC Gasket Breakout Harness is used to access
V
, signal ground, and signal voltage circuits, before
REF
removing valve cover, for the following sensors:
•
Injection Control Pressure (ICP)
•
Brake Control Pressure (BCP)
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
8 DIAGNOSTIC TOOLS AND ACCESSORIES
EGES-270-1
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
The VC Gasket Breakout Harness is also used to
check actuator ground and control for the brake
shutoff valve circuit and ICP system diagnostics.
UVC Sensor Breakout Harness
Figure 522 ZTSE4686
The UVC Sensor Breakout Harness is used to access
V
, signal ground, and signal voltage circuits, after
REF
removing valve cover, for the following sensors:
•
Injection Control Pressure (ICP)
•
Brake Control Pressure (BCP)
4-Pin Injector Harness
Figure 523 ZTSE4662
Advertisement
Chapters
Table of Contents
