Engine Compression Brake Operational Checkout Procedure - Navistar N9 Diagnostic Manual

1 DIAGNOSTIC TROUBLESHOOTING PROCEDURES

9.0 - Engine Compression Brake Operational Checkout Procedure

Step
Perform preliminary operational checkout procedure.
1
Did you perform 1.0 Preliminary Vehicle Operational Checkout Procedure?
Step
Check for related Diagnostic Trouble Codes (DTC).
2
Using Electronic Service Tool (EST) with ServiceMaxx™, check DTC list for:
• SPN 191 Transmission Output Shaft Speed (TOSS) Vehicle Speed Sensor
(VSS)
• SPN 597 Engine Compression Brake Switch
• SPN 4287 Engine Compression Brake Pressure (ECBP)
Does EST DTC list have any of the above listed SPN?
Step Determine if engine compression brake is operating, or is engaged when
3 not commanded On.
Review 0 to 60 snapshot
Does engine brake activate and deactivate properly when commanded?
Decision
Yes: Go to Step 2
No: Go to 1.0 Preliminary Vehicle
Operational Checkout Procedure
(page 23).
Decision
Yes: Go to Fault Code Diagnostics
for appropriate SPN.
No: Perform 0 to 60 MPH Test
(page 2236) while symptom is
occuring, activate engine brake and
deactivate engine brake. Go to
Step 3
Decision
No, engine brake does not activate:
Go to 9.1 Engine Compression
Brake Inoperative (page 126).
No, engine brake does not
disengage when commanded Off:
Go to 9.2 Engine Compression
Brake Engaged When Not
Commanded (page 129).
Yes: Review operator complaint
41