Using Cruise Switches - Navistar International DT 466 Diagnostic/Troubleshooting Manual

Using Cruise Switches

Figure 109 Switches for CRUISE ON and
RESUME/ACCEL
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
3 DIAGNOSTIC SOFTWARE OPERATION
EGES-270-1
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
Reset the change engine oil message feature as
follows:
1. Set the parking brake (required for correct ESC
signal).
2. Turn ignition switch to ON.
NOTE: The entire sequence must be completed within
twelve seconds. The change engine oil message will
now turn off and will activate when the next oil change
is due.
3. Press and release both the CRUISE ON and
RESUME/ACCEL switches four times within 6
seconds.
4. Press and hold both the CRUISE ON and
RESUME/ACCEL switches for 3 seconds.
5. Release both Cruise buttons.
97