96-Pin Breakout Box - Dlc Ii; Breakout Harness Kit - Navistar International DT 466 Diagnostic/Troubleshooting Manual

96-Pin Breakout Box – DLC II
Figure 518 ZTSE4582
The Breakout Box allows testing of the electronic
control system components
connections or piercing wire insulation to access
various signal voltages in the electronic control
system.
CAUTION: The Breakout
measurement only, not to activate or control circuits.
High current levels passing through the breakout box
will burn out the internal circuitry.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
8 DIAGNOSTIC TOOLS AND ACCESSORIES
without disturbing
Box is used for
EGES-270-1
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.

Breakout Harness Kit

Figure 519 ZTSE4505A
The Breakout Harness Kit contains the following
breakout harnesses and test leads:
• 3-Banana Plug Harness (ZTSE4498)
• VC Gasket Breakout Harness (ZTSE4658A)
• UVC Sensor Breakout Harness (ZTSE4686)
• 4-Pin Injector Harness (ZTSE4662)
• 12-Pin Breakout Harness (ZTSE4665)
• 500 Ohm Resistor Harness (ZTSE4497)
• Actuator Breakout Harness (ZTSE4484)
• APS/IVS Breakout Harness (ZTSE4485)
• Pressure Sensor Breakout Harness (ZTSE4347)
• Relay Breakout Harness (ZTSE4596)
• Relay Breakout Harness (ZTSE4674)
• Temperature Sensor
(ZTSE4483)
• Temperature Sensor
(ZTSE4602)
• Turbo Breakout Harness (ZTSE4659)
559
Breakout Harness
Breakout Harness