Navistar International DT 466 Diagnostic/Troubleshooting Manual page 329

7 ELECTRONIC CONTROL SYSTEMS DIAGNOSTICS
ECM chassis ground (Pin A of
connector 9260) using DMM.
Connect engine harness to UVC connector. Use the EST to clear DTCs. If test results are to spec for all test
conditions, but an active code remains, remove valve cover and check between UVC gasket connection and
BCP sensor. (See Circuit Checks for BCP – ECM to BCP Sensor.)
1
Connector 9260 is a 2-wire connector usually located in the battery box. Pin A is the chassis ground connection for the
ECM and IDM. See truck Chassis Electrical Circuit Diagram Manual for complete chassis side ECM and IDM ground
circuit information.
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
resistance from X1-6 to Pin C (spec < 5 Ω).
EGES-270-1
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
325