Fuel Pressure And Aerated Fuel; Fuel Pressure - Navistar International DT 466 Diagnostic/Troubleshooting Manual

222

6. Fuel Pressure and Aerated Fuel

Figure 283
Purpose
To check for correct fuel pressure and aerated fuel
• Ask the operator if the amber WATER IN FUEL
lamp was on during vehicle operation.
• If engine has an optional Engine Fuel Pressure
(EFP) sensor, ask the operator if the amber FUEL
FILTER lamp was on during vehicle operation. If
the lamp was on, change the fuel filter and retest
for poor engine operation.
Tools
• Fuel pressure test gauge
• Fuel Pressure Test Kit
• 1 to 5 gallon bucket
• Fuel/Oil Pressure Test Coupler
Read all safety instructions in the "Safety Information" section of this manual before doing any procedures.
6 PERFORMANCE DIAGNOSTICS

Fuel Pressure

Procedure
possible death or damage to the engine or
vehicle, read all safety instructions in the "Safety
Information" section of this manual.
1. See "DT 466 Performance Specifications" –
NOTE: If engine is equipped with optional Engine
Fuel Pressure (EFP) sensor,
MasterDiagnostics®
pressure.
readings.
CAUTION: Be sure to place a rag or suitable container
under the fuel pressure test valve when bleeding the
fuel rail. Dispose of fuel in a correct container clearly
marked DIESEL FUEL according to local regulations.
NOTE: Engine fuel can be a threat to the environment.
Never dispose of engine fuel by putting it in the trash,
pouring on the ground, in the sewers, in streams, or
bodies of water.
Figure 284 Shrader valve assembly
EGES-270-1
Follow all warnings, cautions, and notes.
© August 2008 Navistar, Inc.
WARNING: To avoid serious personal injury,
Appendix A (page 595) or "DT 570 and HT 570
Performance Specifications" – Appendix B (page
619) for fuel pressure specifications and record
on Diagnostic Form.
software
Compare the EST values to gauge
1. Valve
2. Center stem
use EST with
to monitor fuel