Appendices; Symbols Used; Operating States/Error Signals; Status Display On The Control Panel - Otto Bock 17KO1 Series Instructions For Use Manual

17 Appendices

17.1 Symbols Used

Please note the instructions for use
In some jurisdictions it is not permissible to dispose of these products with unsorted household
waste. Disposal that is not in accordance with the regulations of your country may have a detri­
mental impact on health and the environment. Please observe the instructions of your national
authority pertaining to return and collection.
Type BF applied part
Compliance with the requirements according to "FCC Part 15" (USA)
Non-ionising radiation
Compliance with the requirements under the "Radiocommunications Act" (AUS)
Declaration of conformity according to the applicable European directives
Manufacturer
Protected against dust, protected against splashing water
Serial number
Article number

17.2 Operating states/error signals

The orthosis indicates operating states and error messages with symbols on the control panel and through beeps
and vibration signals.

17.2.1 Status display on the control panel

The current status of the component is displayed on the control panel for 5 seconds in the following cases:
• The button on the control panel was pressed briefly.
• The component was switched on by pressing the
• The battery charger was disconnected from the component.
• Battery charger was connected to the component.
• An error was identified during use.
INFORMATION
No status display due to battery deep discharge
If the status of the component is not displayed on the control panel, the battery may be deep discharged. In this
case it must be charged for at least 15 minutes before the status can be queried again.
C-Brace joint unit 17KO1=*
button.
Appendices
51