Appendices
Sym
Beep
Vibra
bols on
signal
tion sig
the
nal
control
panel
All sym
—
bols on
the
control
panel
light up
altern
ately
—
1 x short
1 x long
and 1 x
—
1 x
at interval
of
approx.
5 secon
ds
—
30 x long 30 x long Severe error/indication of safety
—
—
52
Event
—
Test of the indicators (LEDs) after
connecting the battery charger
—
The product is switched on and
ready for operation
The product was switched on by
pressing the
short
panel.
long
Overheated hydraulic unit
—
A self-test error was detected when
connecting the battery charger.
mode activation (see Page 46)
Switch to safety mode if possible.
—
Charge level 10% to 34%
—
Charge level 34% to 67%
Required action
Check whether all symbols (LEDs) light up
alternately and in the corresponding col
ours.
If a symbol (LED) does not light up in a
colour, the product should be inspected by
an authorised Ottobock Service Centre.
If no symbols (LEDs) light up, the battery
may be deeply discharged. Leave the bat
tery
15 minutes and then repeat this test by dis
connecting/connecting the battery char
ger.
button on the control
Reduce activity.
•
•
Walking possible with restrictions. Please
note the possible change in flexion/exten
sion resistance.
1. Attempt to reset this error by switching
2. If the beep/vibration signal recurs,
3. If the beep/vibration signal recurs, use
charger
connected
Conduct the self-test again by connect
ing/disconnecting the battery charger.
If the
symbol lights up again, the
product must be inspected by an
authorised Ottobock Service Centre.
For disassembly of the joint unit, see
the
section
"Assembling/disas
sembling the joint unit on the orthosis"
(see Page 23).
the product off/on (see Page 41).
attempt to reset this error by connect
ing/disconnecting the battery charger.
of the product is prohibited. The
product must be inspected by an
authorised Ottobock Service Centre.
For disassembly of the joint unit, see
the
section
"Assembling/disas
sembling the joint unit on the orthosis"
(see Page 23)
C-Brace joint unit 17KO1=*
for
at
least