Establishing The Connection Between The Adjustment App And Component; Connecting To The Component; Changing The Units For Weight And Length - Otto Bock 17KO1 Series Instructions For Use Manual

Logging in with a previously saved password
1) Tap the "C-Brace Setup" ( ) symbol.
→ The login screen is displayed.
2) Enter the username and password in the "User name" and "Password" fields. The last 5 users who logged in
on this tablet can also be chosen from the list that is displayed during input.
3) Tap the "Log in" button.
→ After logging in, the length and weight units configured and saved during the user's initial login are used.
To subsequently change the units, see the section "Changing the units for weight and length" (see
Page 25).
→ The screen for establishing the connection to the component appears.
4) See the next section for establishing a connection to the component.

8.3 Establishing the connection between the adjustment app and component

The following points should be observed before the initial connection:
• The component must be switched on (see Page 41).
• Bluetooth of the component must be switched on (see Page 42).
• Bluetooth of the tablet must be switched on.
• The serial number and Bluetooth PIN of the component being connected must be known. They are found on
the enclosed Bluetooth PIN card. The serial number begins with the letters "SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost, the Bluetooth PIN for
an already connected component can be determined using the adjustment app. If the Bluetooth PIN is needed
even to start the adjustment app, please contact an authorised Ottobock service centre. The serial number must
be provided so a new card can be issued.

8.3.1 Connecting to the component

Section "Connect to already saved component:"

8.4 Changing the units for weight and length

To enter the "Height", "Knee Center to floor" and "Weight", the units can be changed between "kg" and "lbs"
or "cm" and "ft / in".
C-Brace joint unit 17KO1=*
1) Briefly press the button on the control panel of the component to activate
recognition (visibility) of the Bluetooth connection for 2 minutes.
2) From the components in range that are shown, select the desired compon­
ent based on the serial number.
3) Tap the serial number to establish a connection.
4) Follow the subsequent instructions on the screen.
5) After the Bluetooth PIN is entered, a connection to the component is estab­
lished.
INFORMATION: If an incorrect Bluetooth PIN has been entered 3
times, it is necessary to wait about 2 minutes before making a 4th
attempt.
→ While the connection is being established, 3 beep signals sound and
the symbol appears in the bottom right corner of the screen.
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the com­
ponent. This process may take up to a minute.
Then the screen for entering the patient data appears.
This section shows the last two connected components. A connection to these
components can be established more quickly by tapping these serial numbers.
"C-Brace Setup" adjustment app
25