Changing The Orthosis Settings Using The Cockpit App; Overview Of Adjustment Parameters In Basic Mode - Otto Bock 17KO1 Series Instructions For Use Manual

Use
INFORMATION
Bluetooth of the component must be switched on to change the orthosis settings. Briefly press the
the control panel to check.
If the symbol is not lit up, Bluetooth has to be activated by a long press of the
Information for changing the orthosis settings
• Before changing settings, always check the main menu of the Cockpit app to make sure the correct component
has been selected. Otherwise parameters could be changed for the wrong component.
• It is not possible to change orthosis settings nor to switch to a different MyMode while the orthosis battery is
being charged. Only the status of the orthosis can be called up. Instead of the
appears in the bottom row of the screen in the Cockpit app.
• If the settings of a MyMode are to be modified, one must first switch to this MyMode.

10.4.1 Changing the orthosis settings using the Cockpit app

Product
MyModes
2. Training mode
Settings
Status
4. User defined
General
Manage components
Imprint/Info

10.4.2 Overview of adjustment parameters in basic mode

The parameters in basic mode describe the dynamic behaviour of the orthosis in the gait cycle. These parameters
act as basic settings for automatically adjusting the damping behaviour to the current motion situation (e.g. ramps,
slow walking speed, etc.).
The stance function and/or the sitting function can also be activated/deactivated. Further information on the stance
function (see Page 27). Further information on the sitting function (see Page 37).
The following parameters can be modified:
Parameter
Stance flexion resistance 120 to 190
Stance function
40
1) Once the component is connected and in the desired mode, tap the
symbol in the main menu.
→ The navigation menu opens.
2) Tap the "Settings" menu option.
change
→ A list appears with the parameters for the currently selected mode.
3) Change the setting of the desired parameter by tapping the "<", ">"
symbols.
INFORMATION: The setting configured using the adjustment app
is marked and, after the setting has been changed, can be
restored by tapping the "Standard" button.
Adjustment Cockpit app
range of the adjustment
O&P profession­ range
al via the adjust­
ment app
+/- 10 of the con­
figured value
0/Off - deactiv­
ated
1/On - activated
button on the control panel.
symbol, the
Meaning
Resistance against flexion motion e.g. when
walking down stairs or while sitting down
Activation/deactivation of the stance function.
This function needs to be enabled in the
adjustment app.
C-Brace joint unit 17KO1=*
button on
symbol