To Install The Stack Mount (M1092A And M1094A) - HP M2350A Service Manual

Mounting the Components
Installing Options 001, 002, 007, 008
To Install the Stack Mount (M1094B)
1. Refer to Figure 6-14 and remove the rear cover:
a. Slide the two spring locks toward the center of the display and lift the cover's lower
edge.
b. Loosen the ground
screw
to detach the grounding wire.
c. Lift and slide the cover out of the rear of the display.
2. Refer to Figure 6-14 and remove the plastic cover:
a. Remove 2 screws securing plastic cover to metal cover.
b. From rear of display, grasp sides of plastic cover and pull cover towards you to release its
inside locking tabs.
c. Spread sides of cover outward to clear locking tabs, tilt cover upwards and remove.
Figure 6-14. Removing
the
Rear Cover and Plastic Cover
3. Refer
to
Figure 6-15
and attach
the top cover stack mount bracket
to
the plastic cover:
a. Stand plastic cover on its front edge, if needed, to brace stack mount bracket in following
step.
b. Place stack mount bracket under plastic cover and insert its two flanges through first
righthand ventilation slot, and second from last lefthand ventilation slot.
6-17