Terminating Cable To Pc Board - HP M2350A Service Manual

Preparing the Site
Preparing and Terminating Cables
HDLUEecorder Cable
AA
P
(computer module)
Use HP 78573 - 60410
PC Board this side.
Terminating Cable to PC Board.
Use HP 78573 - 60411
PC Board this side.
1. Strip outer jacket 2.2 cm (718 "). Be careful not to damage outer shield.
2. Remove foil and filler strips, if present.
3. Unravel and tightly twist outer shield.
4. Strip 6.5 mm (l/4 ") insulation from conductors and twist conductor strands tightly together.
5. Terminate conductors and shield to PC board as shown in diagram. Use a small, flathead
screwdriver to open terminal blocks and insert conductor strands.
6. Attach PC board assembly to faceplate using hardware kit included with the cable assembly.
7. Assemble faceplate to wallbox using screws included with faceplate.
5-28