HP M2350A Service Manual page 41

Introducing the HP Component Central Monitor
System Controls and Connectors
3.
V SHIFT: This is the vertical shift control used to adjust the vertical position of the
displayed video.
4.
H AMP: This is the horizontal amplitude control used to adjust the width of the displayed
video.
5. EAST WEST: This control this is used to adjust the pin- cushion effect of the displayed
video.
6.
Line Protection Fuse Holders: Carries 3.15
A 250 V
fuses for the 200-240 V color
monitors; 4.0 A (slow blow) 125 V fuses for loo-120 V color monitors; 2.0 A 250 V
fuses for the 200-240 V monochrome monitor; and 2.5 A 125 V fuses for the loo-120
monochrome monitor.
7.
Local Power Connector: This is a 3-pin connector, used to input the local line voltage.
8.
System Power Connector: This is a 15-pin "D" type connector, used to output the 60 V DC
supply to a similar connector on the DC/DC convertor in the rear of the Computer Module.
9.
Video In Connector: This is a g-pin "D" type connector, used to input the video signal to
be displayed from the display controller in the Computer Module (DSPC for monochrome
or CDSPC-Video for color).
10. Video Out Connector: This is a g-pin "D" type connector, used to output the video signal
to be displayed on a duplicate display.
11. Human Interface Link Connector: This is an HP-HIL connector, used to transfer
information from the keyboard to the Utility CPU function card in the computer module.
12. Equipotential Grounding Terminal: This is a grounding stud connector, used to connect the
system to an equipotential grounding system.
l-17