HP M2350A Service Manual page 154

Mounting the Components
Installing Options 001, 002, 007, 008
'Ib Install the Stack Mount (M1092A and M1094A)
AIL DIRECTIONS IN TEE3 PROCEDURE ASSUME YOU ARE FACING TEIE REAR OF THE
DISPLAY.
1. Refer to Figure 6-4 and remove the rear cover:
a. Slide the two spring locks toward the center of the display and lift the cover's lower
edge.
b. Loosen the ground screw to detach the grounding wire.
c. Lift and slide the cover out of the rear of the display.
Figure 6-4. Removing the Rea.r Cover
2. Refer to figure Figure 6-5 and remove the top cover:
a. Remove the two screws securing the cover to the display's rear panel.
b. Slide the cover toward you until it encounters resistance.
c. Grip the lower outside edges of the cover. Pull the edges outward and lift the cover
from the display module.
Figure 6-5. Removing the Top Cover
6.12