HP M2350A Service Manual page 40

Introducing the HP Component Central Monitor
System Controls and Connectors
Human Interface Connector (11)
Video Out Connector (IO)
IlwVideo Termination Switch (1)
II II
-
0
0
4 Pi\
' Video In Connector (9)
I I I/
LOA
V AMP
H AMP
Power
(2)
(4)
Connector
0
M1092A/M1094A Display Module Rear View
M1094B Display Module Rear and Side View
1.
Video Termination Switch: On the M1092A and M1094A, this is a push button switch; on
the M1094B, it is a two-pole selector switch. The switch provides 750 or 1kQ impedance
matching
for use as the master or intermediate display. For the M1092A/M1094A it must
be switched ON (in) if only a master display is used and must be switched OFF (out) if
a second, intermediate display is used. For the M1094B the switch must be in the UP
position for a master display, and in
the
DOWN position for an intermediate display.
2. V AMP: This is the vertical amplitude control used to adjust the height of the displayed
video.
1-16