Mounting The Tilt Protection Holders; Figure 17: Variable Length Of The Tilt Protection Holder Depending On The Bend - Binder VDL Series Operating Manual

6.7

Mounting the tilt protection holders

For chambers placed on the optional pump module it is recommended to install the supplied tilt protec-
tion.
Scope of delivery of tilt protection kit (Art.no. 8009-0870):
• 2 screws
• 2 tilt protection holders
Preparing the tilt protection holders
• Depending on the desired wall distance, you can bend the tilt protection holders accordingly.





Figure 17: Variable length of the tilt protection holder depending on the bend

Installation on the chamber
• Plug the two tilt protection holders each with the tab into the mounting holes and push them upward
over the rear panel. The screw holes in the rear wall and in the tilt protection holders must align.
• Fix the tilt protection holders each with one of the supplied screws on the chamber rear wall.
Wall mounting
• Then fix both tilt protection holders on the wall, each with 2 screws Ø 6mm suitable for the wall (B)
VDL (E3.1) 06/2020 Page 69/206