Options; Apt-Com™ 4 Multi Management Software (Option); Analog Outputs For Temperature And Pressure (Option); Measuring Access Port For Vacuum, 9 Poles (Option) - Binder VDL Series Operating Manual

24.

Options

24.1 APT-COM™ 4 Multi Management software (option)
The chamber is regularly equipped with an Ethernet interface (2) that can connect the BINDER APT-
COM™ 4 Multi Management Software.
The MAC Address is indicated in the "Device info" controller menu (chap. 20.1.2).
The actual temperature and pressure values are given at adjustable intervals. Programming can be per-
formed graphically via PC.
Up to 100 chambers can be cross-linked. For further information please refer to the APT-COM™ 4 oper-
ating manual.

24.2 Analog outputs for temperature and pressure (option)

With this option, the camber is equipped with analog outputs 4-20 mA for temperature and pressure.
These outputs allow transmitting data to external data registration systems or devices.
The connection cable is firmly connected to the connection "Analog output" (3b) located in the VDL rear
connection panel. The connection is realized as a 9-poles SUB-D socket as follows:
Figure 25: Pin configuration of the SUB-D socket „Analog output" (8) for the analog outputs option
24.3

Measuring access port for vacuum, 9 poles (option)

The measuring access port allows creating electrical connections for low voltages or sensors between
the exterior and interior of the VDL vacuum drying oven. A 9 poles plug for the outside is included
VDL (E3.1) 06/2020
ANALOG OUTPUT 4-20 mA DC
PIN 1: Temperature +
PIN 2: Temperature –
PIN 4: Pressure +
PIN 5: Pressure –
Temperature range: 0 °C to +110 °C
Pressure range: 0 mbar to 1100 mbar
A suitable plug is enclosed.
Figure 26: Measuring connection (12) with measuring access
port and supplied plug
Page 170/206