Usb Menu: Data Transfer Via Usb Interface; Using The Usb Connection During Chamber Operation - Binder VDL Series Operating Manual

E-mail server settings:
• In the field "Authentication" select the desired
setting "None" or "SMTP" auth".
With the setting "SMTP auth", you can enter a
password under "Email password".
• Select the field "Email user name" and enter the desired user name. Confirm entry with Confirm icon.
• Select the field "SMTP mail server URL" and enter the SMPT mail server URL. Confirm entry with
Confirm icon.
• Select the field "SMTP port number" and enter the desired port number. Standard setting: "25".
Confirm entry with Confirm icon.
• Select the field "Email sender" and enter the desired Email sender. Confirm entry with Confirm icon.
After completing the settings, press the Confirm icon to take over the entries and exit the menu, or press
the Close icon to exit the menu without taking over the entries.
21.

USB menu: Data transfer via USB interface

21.1

Using the USB connection during chamber operation

• Turn the pressure regulator to the end stop of the lock nuts (turn clockwise). The manometer then
shows maximum pressure.
• Open the USB cover on the controller housing (triangle instrument box)
• Observe the display of the manometer: The overpressure must not drop below 25 Pa (recommenda-
tion: 40 Pa).
• Connect the USB stick.
If the USB stick shall remain on the chamber for a longer time, the pressure can be reset to an over-
pressure of at least 25 Pa (recommendation: 40 Pa) on the pressure regulator.
• Remove the USB stick when it is no longer needed
• Close the USB cover on the controller housing (triangle instrument box)
• Now the pressure regulator can be turned back (turn counterclockwise) until there is an overpressure
of at least 25 Pa (recommendation: 40 Pa)..
VDL (E3.1) 06/2020
"Email" submenu.
Select the field "Email server" to access the settings
Page 163/206