Week Programs; Starting An Existing Week Program - Binder VDL Series Operating Manual

19.

Week programs

The MB2 program controller permits programming week programs with real-time reference. It offers 5
week program places in total with up to 100 shift points for each week program.
Main menu > Programs> Week program
Path:
For each program section you can enter the moment in time, the temperature set-point, the pressure set-
point, and the switching states of the special controller functions.
Before starting the program, check the set-points entered in fixed value mode. After the end
of the program, the set-points will equilibrate to these values.
Solvents and forming vapors can ignite if the drying temperature is too high
Fire and explosion hazard when exceeding the auto-ignition temperature of the sol-
vent due to excess drying temperature.
Serious injury or death from burns and / or explosion pressure.
 Make sure that only solvents with an auto-ignition temperature that is higher than
200 °C / 392 °F may be entered into the chamber. Check the auto-ignition temperature
with the safety specifications of the solvent. In the case of solvent mixtures, use the au-
to-ignition temperature of the material with the lowest auto-ignition temperature.

19.1 Starting an existing week program

In Normal display press the Program start icon to access the "Program start" menu.
• In the field "Program type" select the setting "Week program".
• In the field "Program" select the desired program.
• There are no further settings available in the "Program start" menu for week programs, as they are
needed only for time programs.
After completing the settings, press the Confirm icon to take over the entries and exit the menu. The
program starts running.
If instead you press the Close icon to exit the menu without taking over the entries, the program will not
start.
VDL (E3.1) 06/2020
DANGER
"Program start" menu.
Page 151/206