Setting For Condition No.2 To No.8 (For Cutter Plunger) - GRAPHTEC CE7000-130AP User Manual

Setting for Condition No.2 to No.8 (For cutter plunger)

Operation
1
Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
2
Press the [2] key (TOOL).
TOOL setting screen is displayed.
3
Press the POSITION (
4
Press the [3] key (OFFSET).
OFFSET setting screen is displayed.
) keys and set the tool.
2-37
Supplement
Please select Condition No.1 under "Selecting
the Tool Conditions" when setting up tool
conditions for the pen plunger, and choose
"Condition No.2" to "Condition No.8" when
setting up the tool conditions for the cutter
plunger. For more information, see "Selecting
Tool Condition".
Supplement
Press the [1] key to change the CONDITION No.
It will return to CONDITION setting screen
without changing the settings when you press
the [ESC] key (CANCEL).
Supplement
•
What is Offset
It will adjust the difference between the tip
of the blade in the plunger and the center of
the plunger. There are standard adjustment
values for each cutter blades.
Fine adjustment will be made to that standard
values here. (Adjustment will be made with
standard value as 0.)
It is not necessary to set the offset if "PEN",
was selected in the tool settings. (not
displayed)
•
Guideline to Set Offset
See the Cutter Blade Manual
•
You can set the range between -5 and +5.
The other range is +1 to +45.
•
To continue the settings of other tool condition
number, return to step 3 by pressing the [1]
key.