GRAPHTEC CE7000-130AP User Manual page 145

7
Press the [2] key (TYPE No.).
TYPE No. screen is displayed.
8
Press the POSITION (
9
Confirm the setting and press the [ESC] key (PREVIOUS).
TYPE No. will be selected and it will return to CUT LINE PATTERN
screen.
10
Press the POSITION ( ) key (UP MODE).
UP MODE screen is displayed.
11
Press the POSITION (
12
Confirm the setting and press the [ESC] key (PREVIOUS).
It will return to UP MODE CUT LINE PATTERN screen.
) keys and select the TYPE No.
) keys and set the UP MODE.
7-17
Supplement
•
CUT L and UP L is displayed when the TYPE
No. 0-7 is selected. Also, you will be able to
set the UP MODE.
•
Setting for all becomes enabled when USER
is selected.
•
Nothing will be displayed when "OFF" is
selected.
•
If the CUT LENGTH is too long or the UP
LENGTH is too short, the media may get
caught.
In that case, adjust BLADE LENGTH, CUT
LENGTH and UP LENGTH.
Supplement
You can set the range between 1 and 38, and
"UP".
Supplement
•
Value set here will be the cut force for the
uncut part of the perforated lines. Tool will be
raised when set to "UP".
•
Normally, input the smaller value than the
FORCE for cutting to make it half cutting.