When Media Change Mode Is On - GRAPHTEC CE7000-130AP User Manual

When media change mode is ON

The Change Media message appears each time when ending a single cut in Media Change mode.
Choosing to change media will instantly detect the media and proceed to a copy area (cut).
Media switch copies can be made up to the set copy number (designated number).
Operation
1
Plot (cut) the data you want to copy once.
Cutting data is stored in the buffer memory.
2
Press the [COPY] key.
COPY MODE screen is displayed.
3
Press the [1] key (MEDIA CHANGE MODE).
MEDIA CHANGE MODE screen is displayed.
4
Press the [2] key (ON).
Confirm the settings and it will return to the COPY MODE screen.
5
Press the [2] key (NUMBER OF COPIES).
NUMBER OF COPIES setting screen is displayed.
6
Press the POSITION (
setting value.
) keys and increase or decrease the
4-14
Supplement
•
Turning MEDIA CHANGE MODE on will
display the CHANGE MEDIA message each
time after a single cut.
"If the [ESC] key (QUIT COPY) is pressed,
copying will be suspended and it will return to
the default screen.
•
When exchanging media, the media selection
will be chosen from what was selected
before copying.
•
If there is no data in the buffer memory,
"There is no data for copying in the buffer" will
be displayed. Please send cutting data.
•
If too much data is sent from the buffer
memory, "1 copy in the Copy mode buffer!"
will be displayed.
Supplement
It will return to COPY MODE screen without
changing the settings when you press the [ESC]
key (PREVIOUS).
Supplement
The copy number can be set from 1 to 100.