GRAPHTEC CE7000-130AP User Manual page 97

8
Confirm the setting and press the [ESC] key (PREVIOUS).
Number of copies will be selected, and it will return to COPY MODE
screen.
9
Press the [3] key (COPY SPACE).
COPY MODE SETTINGS screen is displayed.
10
Press the POSITION (
setting value.
11
Confirm the setting and press the [ENTER] key (SET).
"COPY" is displayed on the screen, and it will copy as much as
specified.
) keys and increase or decrease the
4-13
Supplement
"CANNOT COPY CUT AREA TOO SMALL!" is
displayed if the cutting area is smaller than the
copy data. Either expand the cutting area, or set
the media that is big enough to copy.
Supplement
•
Copy interval can be set when MEDIA
CHANGE MODE is turned OFF.
•
Copy space can be set from 1.0 mm to 10.0
mm.
•
This setting is maintained even if the power is
turned off.
Supplement
Cutting data is stored even if the media is
exchanged. It can be copied as many times until
the buffer memory is cleared. It can be copied
again after exchanging the media by pressing
[COPY] key.