Table of Contents
Advertisement
2
After the media is detected, the plotter is ready to receive
data for cutting or plotting. This status is called "READY
status" of the default screen.
When setting is finished, the tool carriage's location will
become the initial point.
If the interface or command settings have not been made,
make these settings before sending the data.
If the settings have been made, tool adjustment is performed.
When the pen adjustments have been made, the plotter is
ready to start cutting.
Send the cutting or plotting data from the application
software.
Default screen is displayed.
Menu screen
Supplement
The screen below shows that the plotter is
currently detecting media.
2-30
Advertisement
Table of Contents
Troubleshooting
