HikRobot X86 User Manual page 61

Software Name
Labview
If you need to encrypt software, you can write encrypted information into the platform's internal
memory by calling "MV_OPC_WriteMemory" interface. In the software, you can read and verify
encrypted information by calling "MV_OPC_ReadMemory" interface.
For specific interface calling, please refer to the steps below.
For different Windows versions, the location directory of files mentioned below may differ. Please
refer to the actual condition.
Steps:
1. Right click MVS icon, and select Open file location.
2. Go back 2 levels of directory to find the Development folder.
3. Go to Samples\VC\SimpleSamples\FlashDemo, and find FlashDemo.
4. Obtain flash memory address.
5. Write data into flash memory by calling "MV_OPC_WriteMemory" interface.
6. Obtain flash memory data by calling "MV_OPC_ReadMemory" interface.
If you use third-party software, you need to obtain corresponding dongle.
 Obtain Stream via Labview Software
You can use Labview software to obtain stream for X86 open platform.
Steps:
1. Right click MVS icon, and select Open file location.
X86 Open Platform
·
Supported Versions
Labview 2013, Labview 2014, and Labview 2015
Figure 10-4 Find FlashDemo
51
User Manual