Rd4 Controller; Controller Settings Upon Start Up; Mb2 Controller - Binder VDL Series Operating Manual

9.5.2 RD4 controller

Deactivating the Standby mode (turning on the chamber):
After establishing power supply, press down the Standbybutton for 5 seconds to turn on the chamber.
The controller shows normal display and controls temperature and pressure to the last entered values.
Activating the Standby mode (turning off the chamber):
To turn off the chamber press down the Standby button for another 5 seconds.
When the controller display is dark in standby mode, press any button to activate it for 10 seconds.
9.6

Controller settings upon start up

Depending on the functions activated in the controller, various settings can be requested directly after
turning on the chamber.
Then you should assign a password for the operating level (chap. 12).

9.6.1 MB2 controller

The window „Language selection" enables the language selection, in case that it's activated in the
"Start-up" menu. Afterwards occurs a request of the time zone and the temperature unit.
The controller will function in the operating mode, which was active before the last shut-down. It controls
temperature and pressure in fixed value operating mode to the last entered values and in the program
mode to the set points achieved beforehand.
VDL (E3) 09/2019 Page 95/234