Cleaning And Decontamination; Safety Instructions On Cleaning And Decontamination - Binder VDL Series Operating Manual

26.

Cleaning and decontamination

Clean the chamber after each use to avoid potential corrosion damage by ingredients of the charging
material. .
26.1

Safety instructions on cleaning and decontamination

During cleaning and decontamination, no explosive atmosphere may be present in the installation area of
the chamber and inside the chamber.
Fire and explosion hazard due to explosive atmosphere during cleaning and de-
contamination.
Serious injury or death from burns and / or explosion pressure.
 Before performing any cleaning and decontamination measures, make sure that there
is no explosive atmosphere in the installation area of the chamber or inside the cham-
ber.
∅ Do NOT clean the chamber in potentially explosive areas.
 Before commissioning, ensure that the system is correctly and completely grounded
Prior to renewed startup, allow the chamber to completely dry after all cleaning and decontamination
measures.
Electrical hazard by water entering the chamber.
Deadly electric shock.
 Make sure that the chamber will not become wet during cleaning or decontamination.
∅ Do NOT spill water or cleaning agents over the inner and outer chamber surfaces.
∅ Do NOT put ANY cleaning aids (cloth or brush) into slots or openings on the chamber.
 Make sure that no water will enter into slots or openings on the chamber, especially in
the area of the door hinges.
 Before cleaning, disconnect the power plug. Let the chamber cool down to ambient
temperature.
 Completely dry the chamber before turning it on again.
Avoid electrostatic charges.
Explosion hazard due to electrostatic charge when rubbing with a dry cloth.
Serious injury or death from burns and / or explosion pressure.
 Use only damp cloth when wiping the device. You may use water and the specified
cleaning agents.
∅ NEVER wipe the device with a dry cloth.
VDL (E3) 09/2019
DANGER
DANGER
DANGER
Page 201/234