Setting The Subnet Mask; Setting The Standard Gateway - Binder VDL Series Operating Manual

IP address
IP address
With the arrow-down button you can now change to the enter the subnet mask.
With the Back button you can go back to the "Ethernet" submenu and, repeatedly pressing it, to
display.

20.2.2.4 Setting the subnet mask

Access to this function is possible only if manual IP address assignment has been selected (chap.
20.2.2.1)
Path: Normal display
Press the OK button to enable the setting.
The subnet mask entry is done in four steps, corresponding to the number sections: (1).(2).(3).(4)
Principle of entry:
• Use the OK button to select the desired section of the subnet mask 1/4, 2/4, 3/4, 4/4 in the upper
display line
• Use the Arrow buttons to enter the value for the selected section of the subnet mask
For details please refer to the description of the similar procedure in chap.20.2.2.3 "Assigning the IP
address".
With the arrow-down button you can now change to the enter the standard gateway.
With the Back button you can go back to the "Ethernet" submenu and, repeatedly pressing it, to
display.

20.2.2.5 Setting the standard gateway

Access to this function is possible only if manual IP address assignment has been selected (chap.
20.2.2.1)
Path: Normal display
Press the OK button to enable the setting.
The standard gateway entry is done in four steps, corresponding to the number sections: (1).(2).(3).(4)
VDL (E3) 09/2019
IP address assignment (sample values).
The third section of the IP address is shown. Enter the desired value
with the arrow buttons.
Use the OK button to confirm the entry and proceed to the last section
of the IP address.
IP address assignment (sample values).
The forth section of the IP address is shown. Enter the desired value
with the arrow buttons.
Confirm the setting with the OK button.
Settings Ethernet
Settings Ethernet
Subnet mask
Standard gateway
Page 186/234
Normal
Normal