List Of Materials (Thermoplastic Repair) - Piper Navajo PA-31 Service Manual

Cleaners
ABS-Solvent Cements
Solvents
Epoxy Patching
Compound
Hot Melt Adhesives
Polyamids and Hot Melt
Gun
Hot Air Gun
PIPER NAVAJO SERVICE MANUAL
I
10. This welding method requires a hot air gun and ABS rods. To weld, the gun should be held
to direct the flow of hot air into the fusion (repair) zone, heating the damaged area and rod simultaneously.
The gun should be moved continuously in a fanning motion to prevent discoloration of the material.
Pressure must be maintained on the rod to insure good adhesion. (Refer to Figure 4-34.)
11. After the repair is completed, sand to obtain a surface finish of acceptable appearance.
TABLE IV-II. LIST OF MATERIALS (THERMOPLASTIC REPAIR)
ITEMS
DESCRIPTIONS SUPPLIERS
Buffing and Rubbing
Compounds
Automotive Type - DuPont
*7
DuPont Company
Wilmington, Del. 19898
Ram Chemical# 69 x 1
Ram Chemicals
Gardena, Cal. 90248
Mirror Glaze # 1
Fantastic Spray
Perchlorethylene
VM&P Naphtha (Lighter
Fluid)
Solarite # 11 Series
Methylethyl Ketone
Methylene Chloride
Acetone
Solarite # 400
Stick Form 1/2 in. dia.
3 in. long
Mirror Bright Polish Co.. Inc.
Irvin, Cal. 92713
Obtain From Local Suppliers
Solar Compounds Corp.
Linden. N.J. 07036
Obtain From Local Suppliers
Solar Compounds Corp.
Linden, N.J. 07036
Sears Roebuck & Co. or Most
Hardware
Local Suppliers Temp. Range 300 to
400 F
Revised: 3/11/81 STRUCTURES
1H6