Piper Navajo PA-31 Service Manual page 112

116
ADJUSTMENT
SCREW
Figure 4-1. Landing Light
4-11. LANDING LIGHT.
4-12. REMOVAL OF LANDING LIGHT. (Refer to Figure 4-1.)
a.
To remove either lamp from the landing light mounting plate, remove the screws from the front
of the lamp attachment plate and then remove the attachment plate from the lamp mounting plate. When
removing the attachment plate, use caution not to drop the lamps. Disconnect the electrical leads from the
desired lamps.
b.
To remove the lamp light assembly from the gear strut, disconnect the electrical leads from the
lamps and release the clamps that secure the assembly to the strut housing.
4-13. INSTALLATION OF LANDING LIGHT.
a.
To install the landing light lamps, attach the electrical leads to the lamp(s) and place against the
mounting pad. Position the attachment plate and secure with screws only tight enough to allow the lamps
to fit snug in the mount.
b.
To install the landing light assembly, position the assembly against the strut housing with the
bottom of the mounting bracket 5.63 inches up from the bottom of the housing. (Refer to Figure 4-1.)
Align the bracket longitudinally and secure with clamps. The light beam angle may be adjusted by the
adjustment screws at the sides of the bracket and tilting as desired.
PIPER NAVAJO SERVICE MANUAL
Reissued: 10/12/79
STRUCTURES
1E16