Piper Navajo PA-31 Service Manual page 274

PIPER NAVAJO SERVICE MANUAL
TABLE V-II. TROUBLESHOOTING CHART (CONTROL SURFACES) (cont.)
Trouble
I
Cause
I
Remedy
RUDDER TRIM CONTROL SYSTEM (cont.)
Trim tab fails to
reach full travel.
System incorrectly
rigged.
Check and/or adjust
rigging per Paragraph
5-53.
Either or both trim
drums incorrectly
wrapped.
Check and/or adjust
rigging per Paragraph
5-53.
Trim indicator fails
to indicate correct
trim position.
Trim indicator fails
to indicate any move-
ment.
Trim sender unit not
adjusted properly.
Low voltage in system.
Circuit breaker
open.
Master switch not on.
Adjust in accordance
with Paragraph
5-54.
Check power supply.
Reset circuit breaker.
Turn on master switch.
Trim indicator ground
open.
Trim sender unit de-
fective.
Trim indicator defec-
tive.
Defective wiring in sys-
tem.
Check ground wire.
Replace sender unit.
Replace indicator
unit.
Check wiring.
Trim indicator pointer
moves to extreme
right position.
Trim sender unit
ground open.
Check sender unit
ground.
Reissued: 10/12/79
SURFACE CONTROLS
1L10