Gear Warning Switches Installation; Installation Of Gear Warning Switches - Piper Navajo PA-31 Service Manual

211
1. LEVER, L. THROTTLE
2
2. LEVER. R. THROTTLE
3. ACTUATOR, L. THROTTLE
1
4. ACTUATOR, R THROTTLE
5. SCREW. ADJUSTMENT
6. BRACKET. MOUNTING
3
7 SCREW, ADJUSTMENT
8. BRACKET MOUNTING
9. SWITCH, HORN
10. SPACER BLOCK
11. SWITCH, HORN
12. SPACER BLOCK
13. SPRING, TENSION
12
5
Figure 7-12.
Gear Warning Switches Installation
1. Disconnect the engine control cables from the control levers by removing the connecting
clevis pins.
2.
Remove the flush head screw at each side of the pedestal housing.
3.
Remove the friction knob with washer from the right side of the pedestal.
4. Remove the cap bolts that secure the frame.
5. Pull the assembly from the pedestal housing.
6.
Remove the control keeper tube that holds the switch brackets in the control frame by
removing the tube attachment screws from each side of the frame.
7-38. INSTALLATION OF GEAR WARNING SWITCHES. (Refer to Figure 7-12.)
a. The switch mounting brackets, as part of the control lever assembly, may be installed as follows:
1. Assemble the mounting bracket (switches and spacer blocks may be installed with mounting
brackets), tension springs and spacer washers in the control frame and secure with keeper tube. Secure
keeper tube in frame.
2. Install control lever assembly in the pedestal housing and secure with cap bolts and screws.
LANDING GEAR AND BRAKE SYSTEM
Reissued: 10/12/79
PIPER NAVAJO SERVICE MANUAL
2F20