Piper Navajo PA-31 Service Manual page 213

NOTE 1
TURNBUCKLE STATION IS 308.0
FOR SERIAL NOS. UP TO 31-
712. FOR SERIAL NOS. 31-712
AND UP, STATION IS 291.0.
NOTE 2
APPLY CORROSION RETAR-
DANT COMPOUND WITH
SPRING IN THE EXTENDED
POSITION TO INSURE ALL
COILS ARE COATED REFER TO
LUBRICATION CHART
186
NOTE: BE SURE THE CABLE IS
ROUTED BETWEEN THE
CABLE GUARD
AND THE
PULLEY.
PIPER NAVAJO SERVICE MANUAL
1048
SEE
SEE NOTE 2
1. CONTROL CABLE (FWD. R)
2. CONTROL CABLE (FWD. L)
3. TURNBUCKLE
4. PULLEY CLUSTER
5. PULLEY CLUSTER
6. TRIM CABLE
7. FAIRLEAD
8. PULLEY
9. RUB BLOCKS
10. CONTROL CABLE
11. CONTROL CABLE
12. TURNBUCKLE
13. TRIM CABLE
14. BELLCRANK
15. ROD, CONTROL
16. SPRING, BUNGEE
17. LINE
18. ARM, ELEVATOR
19. TRIM SCREW ASSEMBLY
20. ROD, TRIM CONTROL
21. CABLE END
22. BOLT ASSEMBLY
23. BOLT ASSEMBLY
24. BOLT PIVOT
25. BRACKET
26. ROD END
27. BOLT ASSEMBLY
28. JAM NUT
29. TRIM SCREW ASSEMBLY
30. HOUSING
31. TRIM DRUM
32. SCREW
33. FWD STOP, SCREW
34. ARM. SENDER
35. SENDER
36. SHAFT, SENDER
37. BOLT ASSEMBLY
38. BRACKETSENDER
39. ROD END CLEVIS
40. JAM NUT
41. AFT STOP. SCREW
42. NUT, SENDER
43. WASHER, SENDER
44. ROD, CABLE GUARD
VIEW A-A
SKETCH A
Figure 5-5. Elevator and Elevator Trim Controls
Revised: 5/3/84
1I21
SURFACE CONTROTLS