Piper Navajo PA-31 Service Manual page 102

Table of Contents

Advertisement

PIPER NAVAJO SERVICE MANUAL
TABLE III-I. INSPECTION REPORT
Nature of Inspection
Inspection time (hrs)
L R 50 100500 1000
F. WING AND NACELLE GROUP (Refer to Notes 18 and 30.)
29. Replace pneumatic inlet filter .............................................................................
30. Replace pneumatic pressure line filter. ...............................................................
31. Inspect condition of pneumatic deicers. if installed............................................
32. Inspect air conditioning condenser air scoop rigging. ........................................
33. Check freon level in sight gauge of receiver-dehydrator. Refer to Note 19 and
section X IV )........................................................................................................
CAUTION: The access panel on the upper outboard surface of the wing
which covers the Flux Detector is secured with brass
screws and must be reinstalled with brass screws only.
0 0
0 0
0 0
0
0
0
34. Install inspection plates and panels .................................................................... 0 0
G. LANDING GEAR GROUP
1. Inspect oleo struts for proper extension. Check for proper fluid level as required.........
2. Inspect nose gear steering control and travel. ................................................................
3. Inspect wheels for alignment........................................................................................
4. Put airplane on jacks.........................................................................................................
5. Inspect tires for cuts, uneven or excessive wear, and slippage .........................................
6. Remove wheels, clean, inspect, and repack bearings per lubrication charts. (Refer to
Service Manual, Section II.).................................... ................................................
7. Inspect wheels for cracks, corrosion, and broken bolts. (See Note 37.)
8. Check tire pressure. (Nose: 42 psi; Main: 60 psi.) .........................................................
9. Inspect brake lining and disc for wear.............................................................................
10. Inspect brake backing plates for cracks............................................................................
11. Inspect security of brake and hydraulic lines. (See Notes 30, 38 and 42.)......................
12. Inspect shimmy damper operation....................................................................................
13. Inspect gear forks for damage. ........................................................................................
14. Inspect oleo struts for fluid leaks and scoring. ................................................................
15. Inspect gear struts,, attachments, torque links, retraction links, and bolts for condition
and security and security. ................................................................................................
16. Inspect down lock for operation and adjustment..............................................................
17. Inspect main and nose gear lock rod and cable assemblies for corrosion, freedom of
movement and spring tension. (See latest revision of Piper Service Bulletin No. 860
and Piper Service Letter 755, latest revisions.) ................................................................
18. Inspect torque link bolts and bushings. Replace as required................................................
19. Inspect upper bearing block and retaining pins for damage and remaining components
for excessive wear, corrosion, damage, dents, scratches, nicks and misalignment.
(Refer to Service Manual, Section VII.)...........................................................................
20. Inspect drag and side brace link bolts; replace as required. (See Note 39.) ..........................
21. Inspect security of gear doors and attachments. (Refer to Piper Service Bulletin 682,
latest revision.) ................................................................
22. Inspect warning horn and light for operation. .................................................................
23. Retract gear - check operation. ......................................................................................
24. Retract gear - inspect doors for clearance and operation. ...............................................
0
0
0
0 0
0 0
0 0
0 0
0 0
0
0
0
0
0
Revised: 2/18/94
Interim Revision: 12/02/94
INSPECTION
1E6

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Navajo pa-31-300Navajo pa-31-3

Table of Contents