Piper Navajo PA-31 Service Manual page 756

11-88 . REMOVAL OF LAMP IN OVERHEAD READING LIGHTS. The lamp is
located above each passenger
window with the air vents.
a.
Placing a flat tool between the trim molding and plate at the center, between
the two control units,
pry the plate out, being careful not to bend it.
b. Remove the ground wire from the light assembly
and remove the cover
over the lamp.
c.
Replace the lamp using the proper number.
11-89 . INSTALLATION OF LAMP IN OVERHEAD READING LIGHTS.
a.
Replace the cover over the lamp and connect the ground wire to the light
assembly.
b. Install the plate into the trim molding.
c.
Press the plate into position to secure it in place.
11-90 . DOOR AJAR SWITCHES.
11-91 . REMOVAL OF DOOR AJAR SWITCH. (Serial Nos. 31-2 to 31-32 incl.)
There are two switches
located in the cabin entrance door frame, behind
each striker plate.
a.
Remove the trim panels from the lower half of the door frame.
b.
Remove wires and mark them for positive identification when switches
are
reinstalled.
c. Remove retainer
nuts from end of switches and remove switches from plate.
11-92 . INSTALLATION OF DOOR AJAR SWITCH. (Serial Nos. 31-2 to 31-32
incl.)
a.
Install new switches into plates located behind the door frame.
b.
Secure each switch with a retainer nut.
c. Reconnect the wires to the switch or switches if both were removed.
Ad-
justment should be made at this time.
(Refer to Paragraph 11-93.))
d.
Reinstall the trim panels around the door frame.
Reissued: 10/12/79
ELECTRICAL SYSTEM
PIPER NAVAJO SERVICE MANUAL
4D6