Wire Doubled Over For Installation Of Eyelet - Piper Navajo PA-31 Service Manual

PIPER NAVAJO SERVICE MANUAL
233 A
233 B
Figure 8-28. Lead Assembly
Installed in Grommet
Figure 8-29. Wire Doubled Over
For Installation of Eyelet
16. Install clamps and cable ties as necessary to secure lead to the engine.
8-61. INSTALLATION OF HARNESS. Before installing harness on magneto,
check mating surfaces for cleanliness.
Spray entire face of grommet with a light
coat of Plastic Mold Spray, SM-O-O-TH Silicone Spray or equivalent.
This will
prevent harness grommet from sticking to magneto distributor block.
a. Place the harness terminal plate on the magneto and tighten nuts around the
plate alternately to seat cover squarelyon magneto. Torque nuts to 18 to 22 inch
pounds.
b. Route ignition wires to their respective cylinders as shown in Figure 8-30.
c. Clamp the harness assembly in position.
d. Connect the leads to the spark plugs.
8-62.
SPARK PLUGS.
8-63.
REMOVAL OF SPARK PLUGS.
a.
Loosen the coupling nut on the harness lead and remove the terminal in-
sulator from the spark plug barrel well.
Reissued: 10/12/79
POWER PLANT
2J8