Connecting The Breathing Hoses; Installing The Water Trap And Sample Line - Dräger Apollo Operating Instructions Manual

Chapter 11 - Cleaning and Maintenance

Connecting the Breathing Hoses

WARNING !
Breathing hoses used on the Apollo must
comply with current ANSI standards.
WARNING !
Do not use antistatic or conductive breathing
hoses. There is a risk of burns when using high
frequency electrosurgical equipment.
1. Connect 22 mm (0.87 in) breathing hoses to the
inspiratory and expiratory ports on the breathing
system (1 in Figure
2. Connect the other end of the breathing hoses to
a Y-piece (2 in Figure
filter on the Y-piece.

Installing the Water Trap and Sample Line

1. Push the new or empty water trap into its holder
on the front of the machine(3 in
it clicks into place.
2. Connect one end of the sample line to the Luer
fitting on the water trap (4 in
3. Connect the other end of the sample line to the
Luer fitting on the Y-piece (2 in
Ensure that all Luer fittings are securely
connected.
182
151).
151), or to the optional
Figure 151) until
Figure 151).
Figure 151).
Reassembling Components
Figure 151. Breathing Hose and Water Trap Connections
1
3
4
1
2
Apollo Operator's Manual