Screen Layout; To Configure Layout 1, Layout 2, Or Layout 3 - Dräger Apollo Operating Instructions Manual

Chapter 10 - Configuration

Screen Layout

This screen is used to configure the three default
screen layouts that the user can select during
operation: Layout 1, Layout 2, and Layout 3.
For each layout, the top three options (1 in
117) are used to select the curves to be displayed,
while the bottom three options (2 in
determine the modules that are displayed below the
curves.

To configure Layout 1, Layout 2, or Layout 3:

1. Using the confirm knob, select and confirm the
desired layout.
2. Using the confirm knob, select and confirm a
curve or module.
3. Using the confirm knob, change and confirm the
selection.
When one of the curves or modules is selected, the
available options are displayed at the bottom of the
screen (1 in Figure 118). Any of the curves or
modules can be configured as "blank". Each curve or
module can only be selected once; if the same curve
or module is selected a second time, the previous
one is automatically set to "blank".
152
Configuring the Default Settings in Standby
Figure 117. Screen Layout Standby Configuration Screen
Figure
Figure 117)
1
2
Figure 118. Available Options
1
Apollo Operator's Manual