Beckhoff AX8000 Series Operating Instructions Manual page 54

Mechanical installation
2
1
1
54 ───
► Place the axis module 1 at the right side of the power supply
module 2 onto the screw 3 and carefully press against the
mounting plate 4
► Once again, guide the screws 1 through the rectangular cut-outs
in the module housing 2
1
► Make sure that the plates of the rear panel of Module 1 are not
overlapping and that the modules are sitting flush in cut-out 2.
2
► Bay further modules 2 and screw all remaining screws 1 and 3
tight on the module housings
► Observe tightening torques:
2 Components
Screws M5 x 5
3
AX8000
Tightening torque [Nm]
3
Version: 1.1