Modules - Beckhoff AX8000 Series Operating Instructions Manual

Modules

8.2
Power supply modules
8.2.1
1
2
1
Axis modules and capacitor
8.2.2
modules
Version: 1.1
Mounting example
This chapter provides information on the mounting of power supply
modules and other modules. A power supply module and other axis
modules are bayed as an example.
► Screw screws into the control cabinet mounting plate in accor-
dance with the drilling pattern
► Place the power supply module 1 onto the screw 2 and carefully
3
press against the mounting plate 3
► Guide the screws 1 through the rectangular cut-outs in the mod-
ule housing 2
2
► Screw all the screws tight in the elongated holes in the module
housing
► Observe tightening torques:
Components
Screws M5 x 5
8.2.2
► On all relevant modules, slide the bar for the AX bridge 1 to the
right
The contacts can then no longer be seen.
► Screw screws once again into the control cabinet mounting plate
in accordance with the drilling pattern
1
Mechanical installation
Tightening torque [Nm]
3
AX8000 ─── 53